Optional plaster from the following four aspects to examine (1) depth look at design patterns. General product design patterns plaster relief decoration of irregularities should be more than 10mm, and the production of fine. Thus, after the installation is complete plaster mold lines Which is good, and then the surface of the painting process, still able to maintain a sense of perspective, reflecting the decorative effect. If the plaster relief decoration product design patterns is shallow, only about 5 ~ 9mm, the effect will be much less. (2) See surface finish. Because plaster relief decoration product design patterns, when you install the paint no longer scrub and other processing, so the higher the surface finish requirements. Only surface delicate touch, smooth paint plaster relief decoration product installation, you will have a good decorative effect. If the surface is rough, not smooth, it will give a sense of shoddy paint after installation. (3) See product thickness. Cementitious material is plaster tightness, plaster relief decoration products must have the appropriate thickness, in order to ensure affinity between molecules to achieve the best level, thus ensuring a certain age and in the life of complete safety. If too thin plaster relief decoration products, not only short service life, and affect safety. (4) See the price level where plaster mold lines, compared with the price of high-quality plaster relief decoration, price inferior plaster relief goods cheaper 1/3 to 1/2. The low price was attractive for the user plaster line mold manufacturer, but often in the installation after exposing obvious defects, resulting in regret. Plaster material are generally chosen plaster and synthetic fiber or fiberglass, but look different. Such as gold, blue, light green, brown and other plaster mold lines, sub-modern, European, respectively. Note that the above points when purchasing it. If it is a thing of the past for a long time, very dirty plaster mold, can not use the following approach to deal with. The plaster mold can be immersed in a ratio of 10 to 2000 ml of soapy water plus 40 ml of ammonia water, gently wash about 30 minutes, then remove and rinse with water on it. If it is dirty, very badly by this method can not be cleaned, it is necessary coated copper imitation colors on the plaster mold, it converted into a fake copper statue, it would be more tasteful chic. There are plaster mold lines _ _ Zhengzhou plaster mold lines supplied by ARTEL plaster mold plaster mold Gaomi Artel plant. Gaomi ARTEL plaster mold factory (www.htsgmj.com) (www.htsgmj.com) strong, credible, Shandong Weifang lime, gypsum and other industries has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead ARTEL plaster mold into the brilliant and you work for a better future!