Optional plaster from the following four aspects to examine (1) depth look at design patterns. General product design patterns plaster relief decoration of irregularities should be more than 10mm, and the production of fine. Thus, after the installation is complete, and then the surface of the painting process, still able to maintain a sense of perspective, reflecting the decorative effect. If the plaster relief decoration product lines plaster mold design patterns shallow, only about 5 ~ 9mm, the effect will be much less. (2) See surface finish. Because plaster relief decoration product lines pattern patterns plaster mold manufacturer, the installation can no longer be brushed painting and other processing, and therefore require a higher surface finish. Only surface delicate touch, smooth plaster relief decoration product installation Painted plaster mold production lines, will have a good decorative effect. If the surface is rough, not smooth, it will give a sense of shoddy paint after installation. (3) See product thickness. Cementitious material is plaster tightness, plaster relief decoration products must have the appropriate thickness of the plaster mold lines Which is good, in order to ensure affinity between molecules to achieve the best level, thus ensuring a certain age and complete use period, Security. If too thin plaster relief decoration products, not only short service life, and affect safety. (4) See the price level, compared with the price of high-quality plaster relief decoration, price inferior plaster relief goods cheaper 1/3 to 1/2. The low prices, although attractive to users, but often at significantly exposed after installation defects caused by regret. Plaster material are generally chosen plaster and synthetic fiber or fiberglass, but look different. Such as gold, blue, light green, brown, etc., sub-modern, European, respectively. Note that the above points when purchasing it. Gypsum powder fineness and water absorption rate of the plaster mold life has an important impact. Gypsum powder is too coarse, the mold used for some time, due to corrosion, surface will appear coarse particles, the mold surface uneven, so that the rough surface of the body, affect the finished appearance, reduce die life; but the particles are too small (specific surface area> 1500cm2 / g), since the crystals have a greater stress, strength decreases, also resulting in decreased die life, while the fine through fine gypsum mold poor water absorption. Proved: gypsum powder particle control about 80 percent of maintaining the same particle size and fineness of 120 mesh sieve is less than 1%, not only to the inner surface of the mold has a good feel, and a higher strength and better water absorption rate. Plaster mold lines wholesale prices macro through plaster molds (Certified), Nanyang plaster mold by Gaomi Artel plaster mold factory. Gaomi ARTEL plaster mold factory (www.htsgmj.com) (www.htsgmj.com) Shandong Weifang, lime, gypsum leaders, over the years, the company is implementing the scientific management, innovation and development, the principle of honesty and trustworthiness, the maximum meet customer needs. ARTEL plaster mold in leadership with the staff warmly welcome all inquiries negotiations to create ARTEL plaster mold a better future.