Gypsum and gypsum products, there is a common characteristic - extremely absorbent. Grouting ceramic factory invented molding method blanks on the use of this feature to create. But it is also a drawback of gypsum powder, the store can not be too long a time because there is always more or less moisture in the air, especially in the rainy season and apricot, gypsum powder in the water will increase its quality should be worse, This will reduce it solidified fastness plaster mold, accelerate its clotting time, less than a few minutes marinated lump became, in the end, gypsum will not condense. Pentagram mold making use of high-strength steel or with a knife to manufacture plaster molds, their principles are basically the same. Production methods: ① according to the size you want, in a flat board, with mechanical drawing method Daquan plaster mold, draw a five-pointed star pattern. ② five-pointed star in the center, a vertical thin wooden desired height. Press the plastic five-pointed star pattern with a three-dimensional pentagram ③ clay sculpture or modeling clay, plastic stick should pay attention to the apex of the tip is connected with the five-pointed star of five ribs, composed of these five to ten faces remain flat edges and a straight line. ④ with a hard paper jam or wood veneer in place around the five-pointed star from 1 to 2 cm of a wall surrounding the production of plaster molds, make plaster limited in this range, without loss of waste. While according to the design requirements, so that the gypsum plaster condensed into blocks of various shapes. Daquan plaster mold, plaster mold, plaster mold supplied by ARTEL ARTEL Gaomi plaster mold factory. Gaomi ARTEL plaster mold factory (www.htsgmj.com) (www.htsgmj.com) strong, credible, Shandong Weifang lime, gypsum and other industries has accumulated a large number of loyal customers. The company better work attitude and constantly improving innovative ideas will lead ARTEL plaster mold into the brilliant and you work for a better future!