The purchase of plaster should: 1, the first is to look at the depth of design patterns, plaster molds, plaster relief decoration general product design patterns of irregularities should be more than 10mm, and the production of fine; 2, followed by a look at the surface finish, only the surface After delicate, smooth feel of plaster relief decoration installation paint products, will have a good decorative effect; 3, if the surface is rough, not smooth, after the installation paint will give a sense of shoddy; 4, the last to see the price level, compared with the price of high-quality plaster relief decoration, price inferior plaster relief goods cheaper 1/3 to 1/2. The low prices, although attractive to users, but often at significantly exposed after installation defects caused regret; 5, after stripping plaster mold must have remnants of plaster residue. The traditional way is to use manual operation to wipe, plaster mold Which is good, so the high cost and low efficiency. Plaster line through improved production line, with a special plaster washing machines, which need to use plaster cleaning brush roll. If it is a thing of the past for a long time, very dirty plaster mold, can not use the following approach to deal with. The plaster mold can be immersed in a ratio of 10 to 2000 ml of soapy water plus 40 ml of ammonia water, gently wash about 30 minutes, then remove and rinse with water on it. If it is dirty, very badly by this method can not be cleaned, it is necessary coated copper imitation colors on the plaster mold, plaster mold factory in Shandong, it converted into a fake copper statue, it would be more tasteful chic. 1, the parting line: Option not affect the appearance of the position; select a location in the grout is easy to process; select the location of the mold itself is easy form removal; select products easily deformed position 2, must not be in a hurry to increase the production schedule and the blind a large amount of hardener, otherwise it will greatly reduce the life of silicone mold. Also, please pay particular attention to: mold division in the production of silicon rubber mold is important to note first layer must use the brush mode, make the appropriate proportion of hardener reduce the deployment of the first layer of silicone material, an appropriate extension of time to minimize fixed bubble production. Plaster mold | ARTEL plaster molds | provided by the powerful plaster mold plaster mold Gaomi Artel plant. Plaster mold | ARTEL plaster molds | powerful plaster mold is Gaomi Artel plaster mold factory (www.htsgmj.com) (www.htsgmj.com) this year introduced a new upgrade, the above picture is for reference only, please dial this page Phone or pictures on obtain the latest information, contact: Du Jingli.